7660 Half-Blind Router Table Dovetail Jig with Bit

Cut tight, clean half-blind dovetails for drawers right on your router table. The Woodhaven 7660 holds the workpiece flat and steady while you feed it past the bit, so both hands stay on the work and you never have to balance a handheld router on the edge of a narrow board.

Why a Router Table Dovetail Jig?

• More control: the router stays put in the table. You move the jig, not a spinning router.
• Rock-solid clamping: large clamp knobs and our sliding clamp pads lock the board in place and adjust quickly between parts.
• Repeatable results: the CNC machined template gives the same 7/8" on-center spacing on every drawer.
• Ready out of the box: bit and bit height setup gauge are included.

What's Included

• 7660 half-blind dovetail jig with 1/2" thick CNC machined phenolic template (as tough as aluminum, less expensive to replace if you have an "accident")
• 61780 14° carbide tipped dovetail bit with 5/8" bearing on the shank
• Bit height setup gauge

Specifications

What You Need

• Any router table (the jig does not attach to the table)
• A router that accepts a 1/4" shank bit
• No guide bushing needed. The included bit rides on its own bearing.

Frequently Asked Questions

Does the 7660 cut through dovetails?
No. The 7660 cuts half-blind dovetails, the joint used on drawer fronts. For through dovetails, see the Keller 1500, Keller 1601 or Keller 2200, or browse all dovetail jigs.

How wide a drawer can I make?
The jig handles drawer sides and fronts up to 11-3/4" wide in 1/2" to 3/4" thick stock.

Will it fit my router table?
Yes. The 7660 works with any router table. It does not attach to the table, so there is nothing to mount or modify. Just set it on the table and guide it past the bit.

Can I buy a replacement bit?
Yes. The 61780 dovetail bit is sold separately.

Setup Video and Instructions